Optional
Blade Gap Adjustment With Positive Stops Provide Wide Range Of
Shearing Capacities.
Optional
Nylon Pads Shown On Hold Down Cylinder For Sensitive Workpieces.
Optional Ball
Transfers And Hand Slots Allow Easy Workpiece Handling. (Note:
Safety Barrier Removed)
SQUARING
ARMS: 4’, 8’ and 12’ squaring arms with embedded scales
are available on the left or right hand side of the shear
(NOTE: The length of the squaring arm is measured from the
edge of bottom blade)
SWING
STOP FOR SQUARING ARM: Quick change stops that slide
the length of the squaring arm for varying repetitive work.
POWER BLADE GAP ADJUSTMENT: Infinitely variable adjustment
with electric control. Instantaneously moves blade gap
position at the touch of a button from in position to shear
light gauge material to the out position for heavier
material to cover a wide variety of capacities.
2 POSITION POWER RAKE ADJUSTMENT: Provides the shear
with 2 separate rake angles to allow the most precise cut in
a wide variety of capacities.
48” TRAVEL BACKGAUGE IN LIEU OF STANDARD 36”: Same
heavy duty, front operated, power backgauge with manual
swingaway backstop with 48” of travel.
POWER SWINGAWAY BACKGAUGE WITH 48” TRAVEL: Instantaneously
swings the entire backgauge completely out of the way for
shearing long workpieces, comes equipped with 48” travel.
MANIFOLD
CENTRALIZED LUBE SYSTEM: Brings all lubrication points to a
centralized location for easier maintenance.
AUTOMATIC LUBRICATION SYSTEM: Timed, air powered
lubrication system that automatically brings grease to all
lube points.
5/8” T-SLOTS MILLED IN TABLE OF SHEAR: Slots in
table for stops to be placed in table for repetitive work.
DROP
STOPS FOR T-SLOTS: Disappearing/gravity stops to place
in t-slots to allow workpiece to slide forward over the drop
stops, but not backwards.
36”
T-SLOT SUPPORT ARMS: Heavy duty support arms with 5/8”
t-slots to extend t-slots in table, also available with
embedded scales.
HAND SLOTS IN TABLE: Large slots milled in table to
allow operators to get hands under workpiece for easy
handling.
T-SLOT
ACROSS FRONT EDGE OF SHEAR: 5/8” t-slot across the
front edge of shear to slide support arms the length of the
table.
BALL
TRANSFERS IN TABLE: Heavy duty 2” adjustable ball
transfers to allow easy handling of workpieces recommended
for ½” and larger shears.
HI-CARBON
HI-CHROME BLADES: HCHC blades have more carbon and
chrome than the industry standard blades for use on mild
steel up to 3/8” and stainless up to 10 ga., not for use
with hard metals. Your machine comes standard with a pair
of four edge shock resistant chrome blades which are the
industry standard.
HOLD
DOWN CYLINDERS MACHINED FOR IMPACT PADS: Holddown
cylinders machined to accept nylon pads to protect sensitive
workpieces.
For
more information on the
Standard Hydraulic Shear Options