RDB tube benders that can be
fitted with the table are the models 200-S, 300-S, 300-P, 300-S-w/OCS,
350-S-w/OCS, and the Model 400-S. The positioning table can be attached
or taken off of the tubing bender with ease
The RDB electric programmable tubing bender can be equipped with the
optional tubing bender positioning table. A tubing bender fitted with a
rotary positioning table allows for accurate bends in varying planes, as
well as consistent measurements between bends. This is a must have for a
RDB pipe bender when multiple bends are required on varying planes.
The IDX-10 comes standard with a 10 foot table. We do offer an optional
IDX-15 that features a 15 foot table
The positioning carriage rolls on a precision V block rail and rides the
rail using V-block bearings
The positioning carriage has a heavy duty lubricated gear box that is
used to turn the position of the completed bend to the desired varying
plane. To change the plane of bend, the operator simply turns a hand
wheel and stops at the plane of bend angle (large 360 degree angle
dial).
The table comes with an 8" three jaw chuck with 2-1/2" thru hole that
allows for longer pieces of tubing than the table length. Chuck can
handle up to 4-1/2" OD. The minimum OD is 1/4".
The table has a linear indicator strip so the operator can set up
accurate distances between bends. Mechanical stops can be positioned for
the start of each bend. Using the mechanical stops is very beneficial
for repeatability on bigger production runs.
RDB pipe benders equipped with the tube benders positioning table is
great for hand railing, auto chassis, furniture, marine products,
playground equipment, and hundreds of additional applications.
Like a RDB tube bender, the positioning table is made in America
For more information about the
RDB PROGRAMMABLE PIPE BENDER
call OCEAN MACHINERY today at
(800) 286 - 3624
|
